“Sure, you can drive a stock Jeep through there—that’s what they’re made for!”
“I crossed the Rubicon on 31-inch tires and no lockers!”
“I did the whole trail in 8 hours!”
Mention the name “Rubicon Trail” in any four-wheeling forum and you are bound to hear some boasting, unsolicited advice, and tales of “back in my day…” However, that doesn’t answer your question: What do you really need to do the Rubicon Trail?
Regardless of your wheeling prowess and tire size, there are a few inarguable facts about the Rubicon Trail that you need to take to heart before you leave home:
It changes every day. Just because your buddy with a similar Jeep cruised through Little Sluice last week does not mean you will do so this week. Rocks move every day. Weather varies widely. Trees fall.
There are much tougher obstacles on other trails than you will encounter on the Rubicon Trail. The Rubicon beats you with stamina. It slowly wears you down one rock at a time, increasing the odds of making a bad decision due to mental and physical fatigue.
It’s narrow, it’s busy, and it’s dirty. Passing is difficult. Popular camping areas are loud on weekends. You will be scrubbing dirt out of yourself and your Jeep for days afterwards. Bottom line: Driving the trail isn’t the only challenge with which you will be dealing.
As for your Jeep, it should be in top-form maintenance. Parts and labor are significantly more difficult to acquire on the trail than at home. Steering component, motor mount, axle, and driveshaft failures are the most common breaks. Starting with good basic equipment is key.
It should have at least one locking axle differential. Both front and rear are better. Limited slip and traction control are not the same as a locker.
At least one frame-mounted recovery point (rated for 5000 pounds or more) should be mounted on each front and rear bumper. Yes, factory Wrangler hooks are sufficient, but while bumpers won’t make or break your ability to run the Rubicon Trail effectively, the odds of factory bumpers surviving the trail are slim to none. We call that an “unplanned upgrade opportunity.” You can choose whether to do it before or after the trip.
Factory skidplate protection for the transmission pan, transfer case, and gas tank are adequate on factory Wranglers, but we recommend protection beyond the minimum, especially on your gas tank and diff covers. If you really want to enjoy the trail and minimize stress, consider these aforementioned upgrades, as well as lower front control arm mount protection, 33 to 35-inch tires, and suspension upgrades to allow for those tires, real rocker guards or “sliders,” and better gearing.
Can a lesser vehicle make it? Yes, but it will take more time, with a higher risk of damage. That can create more stress than fun for you and anyone else on the trail that day (oops, some trail-etiquette preaching almost slipped in there). Do these upgrades now—not two or three weeks before your trip. The worst thing you can do is to install a bunch of new stuff on your rig right before the trip and use the Rubicon trail as the “shakedown” run.
The single most important piece of equipment to bring is your brain. Use it before, during, and after the trip. Degrade its proper functioning as little as possible while on the trip. No drinking and driving, wear your seatbelt, pack out your trash, and check on current fire and sanitation restrictions before you depart. Leave the trail for all to enjoy.
After months of waiting for my ordered Jeep Gladiator Launch Edition, I was dying to throw on a few “Barlow” modifications and hit the trail, and I needed to answer one question: How does the Gladiator measure up…
Barlow Adventures owner, Nena Barlow grew up in the Southwest, exploring the back roads by Jeep, horse, and hiking boots. She has been in the Jeep business since 1996, providing tours, 4wd instruction, location scouting, offroad event planning, trail mapping & photography, and recovery.